SCIFIT SXT7000 User Manual download pdf (Page 59)

pivot point just below the foot cushion. Pull the upper body connecting link

(A1848) out of the pivot joint. Do not lose the bushing (A1843, not

shown) that the lower pivot bolt runs through the silver TeleRail bar.

6. Using snap ring pliers, remove the ¾” snap ring holding the black TeleRail

onto the crank arm (A1172).

7. Slide the IGUS thrust bearing (P1179) off the end of the crank arm shaft

followed by the black TeleRail. Do not lose the IGUS thrust bearings.

There is one (1) located on each side of the black TeleRail on the

crank arm shaft.

8. To install, reverse this procedure.

BB. Crank Arm Removal / Replacement

1. Detach TeleRail according to TeleRail Removal Procedure.

2. Remove both crank bolts, using a 7/16” wrench. Older machines had

Allen bolts for crank bolts. These machines require a 3/16” Allen wrench

to remove the crank bolts.

3. Pull the crank arm (A1172) away from the unit and off the end of the

spindle crank assembly (A1542). Do not lose the woodruff key that is

mounted in the slot on the spindle crank assembly shaft.

4. Line up the keyway in the new crank arm with the woodruff key mounted

in the spindle crank shaft.

5. Push the new crank arm onto the spindle crank shaft until the outside of

the crank arm is flush with the outside of the spindle crank shaft.

6. Reinstall crank bolts and tighten to approximately 15 ft/lbs. of torque.

7. Install TeleRail by reversing TeleRail Removal Procedure.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 65

No comments

SCIFIT SXT7000 User Manual Page 59