SCIFIT SXT7000 User Manual download pdf (Page 44)

O. Contact Grip Replacement SX, SXT

1. Insert the head of a small flathead screwdriver between the black plastic

grip and contact grip end cap. Pry the end cap off and set aside.

2. Insert the head of the screwdriver under the corner of each silver plate

and pry away from the black plastic grip. Note: There are cables

connected to each plate.

3. Disconnect the contact grip cable from each silver contact plate on the

SX’s. Disconnect the ski pole cable (P1927 or P2773) from the silver

contact plate on the SXT’s. Do not let the cables fall inside the

handlebars on the SX’s or the ski poles on the SXT’s.

4. Using a small Philips screwdriver, remove the two (2) screws that run

through the center of each black plastic grip. Do not lose the nuts that

are on the opposite side of the black plastic grip as the screw heads.

5. Remove the black plastic grips.

6. Position new black plastic grips and reinstall the screws and nuts in each.

Be careful not to over-tighten the screws as this will cause the black

plastic grip to break.

7. Reconnect the contact grip cable or ski pole cable to each silver contact

plate. Note: The cable with the white stripe connects to the silver

plate that makes contact with the palm.

8. Insert silver plate back into the channel in the black plastic grip. Make

sure not to pinch the cables under the silver contact plate.

9. Install the contact grip end cap.

10. Test the unit in different programs to verify operation. Do not use the

Heart Rate program as it requires the use of a wireless chest strap.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 64 65

No comments

SCIFIT SXT7000 User Manual Page 44