21
• Plug the wireless heart rate PCB back into the upper PCB. It plugs
into the bottom 3-pin header on the right side of the upper PCB (as
shown above).
• The contact heart rate PCB has a cable coming up from the neck of
the unit. This plugs into the top, 3-pin header on the right side of
the upper PCB, above the wireless heart rate header.
• The ribbon cable plugs into the bottom ribbon cable header on the
right side of the upper PCB.
• If your unit has Broadcast Vision, Cardio Theater, etc., the cable
connects to the 8-pin, +8VDC power header. When looking at the
upper PCB from the front, this header is located on the lower right
backside corner of the upper PCB (as shown above).
7. Reinsert the upper PCB assembly into the front of the console.
8. Reinstall the two (2) outer countersunk screws in the back of the plastic
console.
9. Place the display assembly back onto the mounting plate and install the
four (4) display mounting screws.
10. The model of machine must be defined. (You must rotate the TeleRails or
have the wall pack plugged in to power up the upper display to perform
this next procedure.) When the display lights up, see if “UNDEFINED”
appears in the top window. If so, use the UP arrow until the correct setting
is displayed for your unit. The correct setting for your unit is
“ELLIPTICAL” for early software versions, “SX” or “SX1000” for
versions with fixed pedals, “SX” or “SX7000” for BioFlex pedals, or
“SXT” or “SXT7000” for all-body ellipticals. If no unit type appears in the
top window upon power up, the display has probably been preset at the
factory. To verify this, hold the SCAN, SELECT, and PAUSE for three
seconds until “FACTORY SETTINGS” appears, then release. Do not
continue to hold keys once this appears. Press ENTER once. If the
correct unit type appears in the top window, press ENTER eight (8) times
until “UPDATING” appears. If the correct unit type doesn’t appear in the
top window, press and hold SELECT and the UP or DOWN arrow
simultaneously until the correct unit type does appears.
11. Verify operations of the unit by using different programs.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals