SCIFIT SXT7000 User Manual download pdf (Page 38)

• The contact heart rate PCB has a cable coming up from the neck of

the unit. This plugs into the outermost, 3-pin Molex header next to

where the wireless heart rate PCB plugs into.

• When looking at the back of the upper PCB, the Telco cables plug

in along the left edge. The 6-pin plugs into the top plug and the 8-

pin plugs into the bottom plug.

• If your unit has Cardio Key, the cable plugs into the serial port,

which is the 4-pin Molex header lower right corner.

• If your unit has Broadcast Vision, Cardio Theater, etc., the cable

connects to the 8-pin header located at the bottom center of the

upper PCB.

11. Place the console assembly back onto the mounting plate and install the

four (4) display mounting screws.

L. Contact Heart Rate PCB Replacement (Use this procedure for

SX1004’s with serial numbers 905-005171 thru 905-005182, SX7000’s

with serial numbers 911-005228 thru 911-005244, and SXT7000’s with

serial numbers 970-005362 thru 970-005401.)

1. Using a Philips screwdriver, remove the four (4) display mounting screws

on the back of the display mounting plate.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 64 65

No comments

SCIFIT SXT7000 User Manual Page 38