SCIFIT SXT7000 User Manual download pdf (Page 52)

U. Front / Rear BioFlex Cushion Replacement

1. Pull each cushion (A1410 and A1409) away from the saddle assembly

(A1415). Each cushion is attached to the saddle assembly with hook-and-

loop tape (Velcro).

2. Check the condition of the hook-and-loop tape affixed to the v-shaped

brackets on the bottom of the saddle assembly. If needed, replace tape.

New cushions come with both pieces of hook-and-loop tape.

3. Remount the front cushion which has the hook portion of the hook-and-

loop tape affixed to it. Note: The hook portion is the more coarse side

of the hook-and-loop tape.

4. Remount the rear cushion which has the loop portion of the hook-and-loop

tape affixed to it. Note: The loop portion is the softer side of the hoop-

and-loop tape.

5. Verify the cushions and mounting surfaces are mated correctly. Between

the two (2) cushions, there is a stop bar (A1413). There should not be a

gap between the bottom of the saddle assembly and the cushions nor

between the cushions and the stop bar.

Note: The easiest way to tell the difference between the front and rear

cushion is to look at the hook-and-loop tape mounting surface on the

cushion itself. The cushion surface the hook-and-loop tape mounts

to is smaller on the front cushion (A1410). The cushion surface the

hook-and-loop tape mounts to is much larger on the rear cushion

(A1409).

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 64 65

No comments

SCIFIT SXT7000 User Manual Page 52