SCIFIT SXT7000 User Manual download pdf (Page 56)

Y. Interior Roller Replacement (Old) (Use this procedure for all

SX500’s, SX1004’s with serial number 905-005170 and below, SX7000’s

911-005205 and below, and SXT7000’s 970-005330 and below.)

1. Remove the acorn nut at the rear of the TeleRail, using a 9/16” wrench.

This nut is located on the bolt that holds the silver TeleRail bar to the black

frame.

2. Using a 3/16” Allen wrench and ½” wrench or socket, remove the bolt, lock

washers, and nut from the rear of the silver TeleRail bar.

3. Lift the rear of the TeleRail bar out of the vertically mounted brackets

welded to the black frame. Do not lose the bushing (A1533) that goes

through the rear of the TeleRail bar.

4. Support the black TeleRail and pull the silver bar out the rear. Do not let

the black TeleRail fall when pulling out the silver bar.

5. Using a 5/32” Allen wrench, remove the bolt running through the middle of

each roller (P1557).

6. Remove each roller and install the new roller in its place.

7. Use a small amount of green loc-tite on the end of each bolt. Insert the

bolts back through the rollers and tighten down.

8. Reinsert the silver bar, roller side up, back into the black TeleRail.

9. Inspect the IGUS bearings (P1561) for damage. Replace, if needed.

10. Slide the bushing through the rear of TeleRail bar.

11. Place the rear of the TeleRail bar into the vertically mounted brackets

welded to the black frame.

12. Line up the holes and insert the bolt from the outside to the inside.

13. Place the lock washer followed by the nut on the bolt. Tighten the nut.

14. Screw an acorn nut on the end of the bolt and tighten.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 64 65

No comments

SCIFIT SXT7000 User Manual Page 56